Flared Ferrule Fitting for fuel and oil lines to be silver soldered onto 5/16" OD tubing and used with nut E75980 also availible.

Inverted Ferrule Fitting for fuel line connections to be silver soldered onto 5/16" OD tubing and used with nut F75314 also available.

Nut for Flared Ferrule Fitting E76000 for fuel and oil lines to be silver soldered onto 5/16" OD tubing. Thread is 9/16" BSF.

Nut for Inverted Ferrule Fitting F75315 for fuel lines to be silver soldered onto 5/16" OD tubing. Thread is 1/2" x 24tpi

Carburetor float lever for operating needle valve. P2 up to chassis 100 MY

Spring plate for oil pressure relief valve

Attach Badges to your Badge Bar and Dress up your car

Fuel filter paper element conversion for Late British P1 from chassis number 102 WR using Zenith filter mounted on side of engine

Gasket set for inlet manifold to cylinder head- Aluminum Head engines only.
Set includes just the four gaskets shown

Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.

Replace the original filter screen with a modern paper type replaceable element using this adapter set-up.

Exhaust valve seat for aluminum cylinder head

Inlet valve seat for aluminum cylinder head

Ignition Contacts for Late Phantom 1 and late 20hp on

Lock Tab Washer Set for Phantom 1 engine

Valve seat for inlet and exhaust for G2B series on, aluminum head

Replace the original Enots fuel filter element (Brass washer stack type with a modern paper element that is easier and quicker to service, less likely to congest, and still maintains the original appearance

points, ignition contacts for late Br. Ghost, Early P1, Early 20 to L- Series.

Carburetor needle and seat valve. Includes aluminum sealing washer. Applies to early Phantom 2 to chassis 102 MY.

Spring for cam follower

Ignition Ballast Resistor complete

Float chamber cover, reproduced.

Bushing set for connecting rod small end P1,P2. Requires fitting and honing to proper clearance.

Carburetor inlet exhaust heated chamber (hot spot) bottom cover plate. New Old Stock

Cylinder Head Gasket for Iron Head, reproduction

Cylinder Head Gasket for Aluminum Head, reproduction

Ignition coil reproduced for exact appearance of the original. Coil value is suitable for either points ignition or Pertronix Electronic Ignition Systems. Carries a 30 month warranty.

Presently available for immediate dispatch!

Rollers and pins for UN-Splined cam followers. Before ordering verify which ones your engine has. Typically earlier series cars had un-splined followers, but some cars may have been changed to the splined type. When replacing rollers and pins it is recommended to use a special fixture to prevent pinching the fork onto the roller. Also it is best to replace the cam follower springs as well.

Rollers and pins for Splined cam followers. Before ordering verify which ones your engine has. Typically later series cars had splined followers, but some cars may have been changed to the un-splined type. When replacing rollers and pins it is recommended to use a special fixture to prevent pinching the fork onto the roller. Also it is best to replace the cam follower springs as well.