Flared Ferrule Fitting for fuel and oil lines to be silver soldered onto 5/16" OD tubing and used with nut E75980 also availible.

Nut for Flared Ferrule Fitting E76000 for fuel and oil lines to be silver soldered onto 5/16" OD tubing. Thread is 9/16" BSF.

Banjo fitting for fuel lines and oil lines such as carburetor feed pipe, auto vac connection and some oil lines must be silver soldered on, fits 5/16" OD tubing 1/2" center opening

Seal- Bijur tank to firewall rubber fume seal. This part is actually a Post-War model part, however it is a good item to use on late Pre-War cars to help control fumes from entering the driver's compartment.

Starter drive retaining ring

Corrugated gasket for exhaust manifold to down pipe connection. Sold in pairs.

Steel disc external splined starter drive

Attach Badges to your Badge Bar and Dress up your car

Clutch disc starter drive

Rubber pad set for screw that attaches firewall to scuttle

Points ignition contacts includes RH8889 and RH8891. Sold in sets to replace both per car. Fits Wraith A, B, and part of C Series and all six cylinder Post-War cars.

Spacer spherical for exhaust manifold to down pipe connection

Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.

Cover for starter relay switch for later 20/25 and later Phantom II on

Wrench for DWS jack top. Safely remove the eight sided cap with a proper fitting tool that will avoid distorting and damaging threads.

Starter Brush Set

Wheel Hub Grease Cap Retainer, Left Handthread, New Old Stock

Rubber fuel pump mount, reproduction. For chassis mounted SU fuel Pump.

Rubber seal set for DWS hydraulic jacks and pump. When rebuilding your jacking system it is necessary to replace all of the rubber seals. This set will do all the jacks and the pump. They are compatible with silicone brake fluid. It is recommended to use silicone brake fluid to reduce corrosion and permit quicker retracting. Alvis, Lagonda, and other makes using DWS Hydraulic Jacking systems can also use this kit.

Coil for Pre-War cars to mount on original pedistal with two studs. The appearance of this coil is subject to change.

Pedal pad set

Clip for Lucas bulb holder

F60895K Bijur Chassis Lubrication tank/pump rebuild kit for later Pre-War cars. Includes all perishable parts such as gaskets and filters

Starter motor brush cover.

DWS Jack Pump control knob, front. Reproduced in stainless steel. May require some slight machining to fit shaft due to slight variations in sizing of shafts.

DWS Jack Pump control knob, rear. Reproduced in stainless steel. May require some slight machining to fit shaft due to slight variations in sizing of shafts.

DWS Jack Pump control knob, release. Reproduced in stainless steel. May require some slight machining to fit shaft due to slight variations in sizing of shafts.

Rebuild kit for carburetor, Zenith single throat. Includes gaskets, accelerator pump, aluminum sealing washers, needle and seat, name badge, and idle screw

Clip only for holding the Lucas Inspection Lamp #97 and similar