Flared Ferrule Fitting for fuel and oil lines to be silver soldered onto 5/16" OD tubing and used with nut E75980 also availible.

Nut for Flared Ferrule Fitting E76000 for fuel and oil lines to be silver soldered onto 5/16" OD tubing. Thread is 9/16" x 18tpi FOR SPRINGFIELD CARS ONLY

Banjo fitting for fuel lines and oil lines such as carburetor feed pipe, auto vac connection and some oil lines must be silver soldered on, fits 5/16" OD tubing 1/2" center opening

Carburetor float lever for operating needle valve. P2 up to chassis 100 MY

Spring plate for oil pressure relief valve

Rotor ignition for DeJon distributor only

6 volt cars, such as late Springfield Silver Ghost and Springfield Phantom 1 require this lower resistance coil.

Distributor cap for DeJon distributor only.

Friction lining large crank damper P1,P2early series

Gasket set for inlet manifold to cylinder head- Aluminum Head engines only.
Set includes just the four gaskets shown

Aluminum Washers are great for sealing connections involving fuel, oil, and coolant. Included are the most common sizes found on most Rolls-Royce and Bentley motorcars. The sizes and quantities are listed in the extended information tab.

Reproduced in reinforced rubber as original

Replace the original filter screen with a modern paper type replaceable element using this adapter set-up.

Exhaust valve seat for aluminum cylinder head

Inlet valve seat for aluminum cylinder head

Cylinder head water jacket rear cover plate

Lock Tab Washer Set for Phantom 1 engine

Valve seat for inlet and exhaust for G2B series on, aluminum head

Ignition points set for American Bosch Distributors

Carburetor needle and seat valve. Includes aluminum sealing washer. Applies to early Phantom 2 to chassis 102 MY.

Spring for cam follower

Tappet cover for aluminum head SP1

Float chamber cover, reproduced.

High Speed jet return spring cap (Springfield only) does not include spring

Wrench for Silver Ghost valve port caps, Springfield Phantom I engine oil drain plug and transmission oil filler plug. Reproduction

Bushing set for connecting rod small end P1,P2. Requires fitting and honing to proper clearance.

AB6- Electronic Ignition Conversion for Springfield Silver Ghost + Springfield Phantom 1. This conversion is for the Bosch distributors only. At the time of placing an order for these, you must specify 6 volt or 12 volt, Negative or Positive ground. It is recommended to use the .6 ohm coil with this conversion.

Water pump drive coupling

Cylinder Head Gasket for Iron Head, reproduction

Cylinder Head Gasket for Aluminum Head, reproduction